These seats started out from the MPC ’76 Camaro annual kit and with most parts that old were pretty simple. The seat pattern on the face with the round buttons is what made these the ideal choice. After the initial cleanup, I began adding some extra detail which included round beading to match the factory seams. Then seat hinges on the sides an a simple seat back cover to finish it off. Sorry, the matching rear seats are not ready.
This intake used for the master started from the AMT 70 1/2 Baldwin Motion kit. The original piece didn’t fit the kit engine so what started out as simply extending it turned into an all out making it look like it’s full-scale counterpart. The 1:1 intake I referenced is the 1968 – 1969 Camaro Big Block Aluminum Intake Manifold, GM 3933163.
These are cast from a Monogram 1/24 Pro Street Firebird kit. They are a pretty nice detailed part on there own so they are box recast. What I offer is a super clean casting that I won’t sell if I see any issue. The only drawback is they are 1/24 an are too big for 1/25.